Hi everyone,
I'm currently working with b-spline surfaces in OpenCASCADE, and I noticed that both "GeomFill_BSplineCurves" and "GeomFill_ConstrainedFilling" can be used to generate b-spline surfaces by passing in three or four b-spline curves. However, I'm curious if there are any differences in the results produced by these two classes?
Additionally, I also noticed that FreeCAD only uses the "GeomFill_BSplineCurves" class while Analysis Situs only uses "GeomFill_ConstrainedFilling". Can anyone explain why this might be the case?
Thanks in advance for your help!
I'm currently working with b-spline surfaces in OpenCASCADE, and I noticed that both "GeomFill_BSplineCurves" and "GeomFill_ConstrainedFilling" can be used to generate b-spline surfaces by passing in three or four b-spline curves. However, I'm curious if there are any differences in the results produced by these two classes?
Additionally, I also noticed that FreeCAD only uses the "GeomFill_BSplineCurves" class while Analysis Situs only uses "GeomFill_ConstrainedFilling". Can anyone explain why this might be the case?
Thanks in advance for your help!