zhangjiawang
Looking around for some CAD
I would like to ask if the "GeomAPI_ExtremaSurfaceSurface" class has any limitations when it is used to calculate the parallelism of two topological surfaces?
I tested two cylinder surface . the result are as follows:
1. If any cylindrical surface is larger than PI in the U direction.there are two extreme points in the calculation result, and the two extreme values are not equal.
2. If both are less than PI, then two extreme values are calculated and they are equal to a certain loose precision.
I tested two cylinder surface . the result are as follows:
1. If any cylindrical surface is larger than PI in the U direction.there are two extreme points in the calculation result, and the two extreme values are not equal.
2. If both are less than PI, then two extreme values are calculated and they are equal to a certain loose precision.