I stumbled upon this treasure mine of a website today
and I found
after browsing for a bit.. totally unrelated to what I was looking for but as a CNC programmer, creating a stock model for a turned part is very important.
I had been wondering for a long time how one would approach this problem, low and behold I would learn this from you, Quaoar!
thank you again.
I was actually looking for a good approach to create snap points like a mid point, or the center of a circle.
and I found
after browsing for a bit.. totally unrelated to what I was looking for but as a CNC programmer, creating a stock model for a turned part is very important.
I had been wondering for a long time how one would approach this problem, low and behold I would learn this from you, Quaoar!
thank you again.
I was actually looking for a good approach to create snap points like a mid point, or the center of a circle.