Hi all,
Has any of you had any experience with Geometric constraint solvers? As far as I know OCCT doesn't have this implemented so I'm wondering how involved such a system would be for 2D and 3D.
FreeCAD has one implemented in the Sketcher module and for the most part I found it working reasonably well for basic constraints. I had issues with tangential constraints (Line-Circle). It would give undeterministic results for a fully constrained sketch so I opted for manual scripting usually. Hopefully this has been sorted out in the new release.
Anyhow, I'm a bit suprised that OCCT doesn't have it implemented which leads me to believe that it is probably quite complicated?
Any thoughts?
Has any of you had any experience with Geometric constraint solvers? As far as I know OCCT doesn't have this implemented so I'm wondering how involved such a system would be for 2D and 3D.
FreeCAD has one implemented in the Sketcher module and for the most part I found it working reasonably well for basic constraints. I had issues with tangential constraints (Line-Circle). It would give undeterministic results for a fully constrained sketch so I opted for manual scripting usually. Hopefully this has been sorted out in the new release.
Anyhow, I'm a bit suprised that OCCT doesn't have it implemented which leads me to believe that it is probably quite complicated?
Any thoughts?